Categories
FreeBSD How to

How to configure IPv6 DHCP client for XS4ALL on FreeBSD

For this installation you might be required to first establish the connection, check: How to use a PPPoE or PPPoA connection of XS4ALL on FreeBSD.

First you need to install a DHCP client

Setup config for dhcp6c

Add the following

Add the following to /etc/rc.conf

Now startup the client

As last set the default route

To test the connection you should be able to ping XS4ALL.

2 replies on “How to configure IPv6 DHCP client for XS4ALL on FreeBSD”

Leave a Reply to How to configure a IPv6 gateway for XS4ALL on FreeBSD – Marius van Witzenburg Cancel reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.